HDPE Swing Check Valves

CLOSING THE DISC BY SPRING ACTION

The valve closing action is made by two springs that are connected to an articulated mechanism. This design allows a small force from the springs over the mechanism to hold a higher closing pressure of the disc.

BENEFITS:

* Light Weight.

* Last Longer.

* Low installation Cost.

* Low Freight Cost.

APPLICATIONS:

* Irrigation

* Water Work

* Pump Stations

IMPORTANT CHARACTERISTICS OF THE HDPE CHECK VALVE

* Valve Body made of High-Density Polyethylene (HPDE).

* The closing mechanism is designed to close a moment before the flow is reversed. This action decreases the loud hammering sound of the water hammer. The flap cannot jam in the open position.

* All the working mechanism is made of 316SS. STANDARD.

* The closing contact of the disc is performed by HDPE and rubber, eliminating wear and tear.

* The disc is made of extra durable HDPE, will not drip or stick.

* The comprehensive design of the valve body allows a flow without restrictions.

* Regardless of the position in which you install, horizontal, vertical, or inclined, the check valve will operate normally and effectively.

* Easy inspection and maintenance due to its simple design.

* Maximum working pressure of 150 psi (10.5 Bar).

* The closing mechanism will open at less than 5psi.

* Valve body and disc are completely resistant to all kinds of corrosion.

* The sizes range from 3" to 12".